Carbon Fibre Finish Licence Plate Frames

Give your plates a clean, aggressive finish with our carbon fibre finish licence plate frames. Molded from high-grade carbon fibre plastic, they're tough, lightweight, and built to handle daily wear without losing their edge.

Each frame measures 31.7cm × 15.7cm (12.5" × 4.9") on the outside, with a 2.5cm (1") border along the top and bottom and a 1.3cm (0.5") border on each side. That leaves an inner window of roughly 29.1cm × 10.6cm (11.5" × 4"), sized to fit most standard plates, including Australian slimline plates and American/Canadian standard plates. As always, double-check your plate's dimensions before ordering.

The low-profile design sits flush against your plate without covering any numbers or lettering, and installation is straightforward: pre-drilled mounting holes and all hardware are included, so there's no drilling required. Matching screw caps snap over the mounting screws for a seamless, factory-fresh look.

Each set includes 2 frames, mounting screws, and screw caps: enough for a matching front and rear finish.